What are the installation methods for lean pipe connectors?

There are various installation methods for wire rod connectors. Below, we will introduce aluminum alloy lean pipes, mainly based on the connection angle, load-bearing requirements, and usage scenarios. The common installation methods are as follows:

Common types of connectors and installation methods

-90 degree external fastener
-Place two lean tubes at the fastener port and tighten the screws with a wrench.
-Used for external right angle or cross connections, easy to install.

-L-shaped external fastener
-Insert the two pipes into the fastener ports respectively, tighten the screws and adjust them to the vertical L-shape.
-Make sure the pipe is fully inserted before tightening.

-45 ° slant support fastener
-Both ends are fixed to two vertical pipes, forming an equilateral triangle structure without the need for a short pipe in the middle, resulting in high stability.

-Universal joint fasteners (outer/inner)
-External fastener: externally installed, adjustable at any angle.
-Internal expansion fastener: Concealed installation inside, supporting multi angle connection.
-After installation, it is necessary to check whether the activity is smooth.

-Cross clip
-Used for connecting two pipes that are perpendicular to each other but not in the same plane, optional reinforced type to enhance load-bearing capacity.

-Parallel clip/double snap ring clip
-Used for connecting two parallel pipes, the former is selected according to its bearing capacity, while the latter is fastened externally and screwed.

-Straight line expansion fastener
-Insert two ports inside for extended connection, achieving hidden docking.

-Profile adapter block
-Insert the groove into the aluminum profile, then install the lean tube and tighten it for the connection between the lean tube and the aluminum profile.

-Expansion universal casters
-Insert the lean pipe port into the caster rod and tighten it for easy movement. Choose the wheel diameter according to the load-bearing capacity (such as a 3-inch load-bearing capacity of 90kg).

-Sliding sleeve&rotating sleeve
-Sliding sleeve: allows for distance adjustment along the pipe.
-Rotating sleeve: achieves circular rotation and cannot be translated.

-Plastic sealing
-Directly cover the pipe port tightly, dust-proof and aesthetically pleasing.

-Profile end face connection sleeve
-When used in conjunction with the supporting foot, when the bolt diameter is less than 28mm, insert the screw and fix the pipe into the connecting sleeve on the ground.

Summary of installation points
1. Tool requirements: Most connections only require a hex wrench or a regular wrench.
2. Pre installation inspection: Ensure that the pipe is fully inserted into the connector port before tightening.
3. Structural optimization: It is recommended to use reinforced fasteners or slant support triangular structure for heavy or highly stable structures.
4. Hidden installation: Internal expansion connectors are suitable for occasions with high appearance requirements.