Installation method of aluminum alloy lean pipe connectors

The installation of aluminum alloy lean pipe connectors is an important part of industrial assembly, and the correct installation method can ensure structural stability and service life. The following are the installation methods and precautions for various types of connectors.

1、 Common types of connectors and installation methods
1. Installation of 90 degree external fasteners
Installation steps:
Place two lean tubes at the two ports of the 90 degree external fastener;
Use a wrench to tighten the fastening screws;
Check if the connection angle is accurate;
Features: Used for external right angle or cross connection of lean pipes, easy to install.

2. Installation of L-shaped external fasteners
Installation steps:
Insert two lean tubes into the two ports of the L-shaped fastener respectively;
Tighten the screws with a wrench;
Adjust to L-shaped vertical state;
Caution: Ensure that both pipes are fully inserted into the port before tightening.

3. 45 ° slant support fastener installation
Installation process:
Use two fasteners to fix each end of two vertically connected lean pipes;
Connect these two fasteners with a short lean tube in the middle;
Make the three tubes form an equilateral triangle;
Advantages: This structure has better fixation effect and high stability.

4. Installation of universal fasteners
Installation Guide:
External fastener: externally installed, adjustable pipe to any angle;
Internal expansion fastener: Internally installed, supports hidden multi angle connection;
Attention: After installation, it is necessary to check whether the movement in all directions is smooth.

5. Installation of cross fasteners
Installation instructions:
Used for two pipes that are perpendicular to each other and not in the same plane;
The external fasteners are fixed in a cross shape;
Hidden connections can be achieved using built-in connectors or anchor pins;
Tip: For heavy-duty frames, it is recommended to use reinforced cross fasteners.