Our commonly used aluminum pipe diameter is generally OD 28mm. In fact, aluminum pipe size is far more than these. There are 5 kinds of customized sizes in mold opening alone.

Today I'm going to introduce you to one of them:

The diameter of this model is 27.9mm. If you don't use calipers, you can't see the difference with 28mm. Its wall thickness is 1.6-1.7mm, which is relatively thick for aluminum pipes. It can also be fitted with ordinary aluminium pipe fittings.

With the development of the industry, aluminum pipes are also used more widely, the major factories are more strict requirements for its material, so SUNQIT aluminum pipe lean tube is also very popular in the industry. If there are any other problems, welcome to consult !

　　Lean pipes need to be designed with load capacity in mind. Strength can be increased by adding fulcrum, connecting parts and parallel use of double cladding plastic pipes. When designing the structure, make sure that the main load is applied directly to the pipe fittings and not to the connections.

　　The maximum horizontal distance is every 600mm (according to the specific weight of the design of the specific structure) can be built at will, using block type assembly, must be vertical with the ground column support, and every 1200mm, vertical column should be directly to the ground. In the case of products with casters, the underframe shall be of double rod parallel construction. The horizontal distance is 600mm, and the safety bearing of a single rod and slide is 30kg. A whole plastic covering than by the collet string up a few plastic tube strength is stronger, so in the plastic covering tube selection, the stress rod must be the whole rod, the connecting rod can be segmenting.



　　When designing a rod product, the usage should be considered in detail. If it does not need to move, try not to design a product with casters. Line bar products are also known as flexible, according to your site conditions and customer requirements, comprehensive design scheme, flexible disassembly and installation, no welding, practical, automotive, electronics, printing, clothing, dust workshop, installation is more health, no pollution.

　　The width of each column of the sliding shelf (center distance) is the width of the turnover box placed +60mm; The height of each floor is +50mm of the height of the turnover box placed. The determination of the slope Angle of the slide, the general slope Angle of the slide is 5~8 degrees, when placing precision materials, heavy materials and the bottom of the turnover box is smooth, the slope Angle should be smaller.

　　There are many domestic lean management manufacturers, east China, pearl River Delta, southwest and other regions more, so where are shenzhen lean management manufacturers Shenzhen has less and less factories now, mainly gathered in Shenzhen’s guanwai, relatively more cost and transportation is also convenient.



　　SUNQIT is located in shenzhen longhua district mission hills around foxconn factory, founded in 2005, so far for 18 years, and its business scope from domestic radiation in India, Italy, Vietnam and other places, have worked with many large manufacturing enterprises, have their own lean pipe production equipment, stamping machine, slide rail production line, corrugated board production line, etc.