Lean pipe equipment general assembly of principles and theories to the side with the film after the assembly line workbench. First the install assembly line workbench bearing pipe with two ends before they are installed in the middle. All between chuck and can are installed according to the requirements of design to ensure that each clamp screw in place. Can't use hard and chuck can hammer. To ensure the perpendicular to the ground when packed column. In order to avoid the uneven force of the whole wire rod frame to cause damage note: When cutting the plastic tube, pay attention to the deformation of plastic tube cutting. There may be special purpose members, such as insert frame, hook, etc., which need to be processed and configured.
1. Install the connecting rod after side film and film.
2. Install the load-bearing rod and then install the connecting rod.
3. Then install the two ends and then install the middle, and all the plastic tubes are installed in place according to the design requirements.
4. All chuck and plastic pipe are installed in place according to the design requirements.
5. Ensure that each chuck screw is tightened in place.
6. Do not beat the plastic tube and chuck with a hard hammer.
7. When installing the column, ensure that it is perpendicular to the ground, so as to avoid the uneven force of the whole wire rod frame, thus causing damage.
8. Finally, ensure that each screw is tightened in place, and the plastic tube can not be beaten with a hard hammer. When installing the column, ensure that it is perpendicular to the ground, so as not to cause damage to the whole lean tube shelf by uneven force. (Note: when cutting the plastic tube, pay attention to the cutting deformation of the plastic tube. There may be special-purpose components, such as insert frame and hook, which need to be processed and configured.)
At present, the products composed of wire rods are suitable for testing, maintenance and product assembly of various industries; Make the factory cleaner, the production schedule easier, the logistics smoother. It can adapt to the needs of modern production constantly improving, in line with man-machine principle, so that the field staff operating standards, comfortable, the idea of the environment and creativity quickly realized, at the same time, it has the characteristics of light, strong, clean and wear-resistant surface. Also, assembly line workbench connectors: any time you want to change. It is easy to realize how to change the assembly operation of H series connector. The required positions of two pieces of stuck pipe can be combined according to the position and add M6 Angle screw, and the installation process can be completed by using M6 inner hexagon wrench.