News
Position: HomeNews

What are the design points of lean pipe?

Source:News 2021-09-16 13:47:55 6 Lean pipe Line bar

Lean pipes need to be designed with load capacity in mind. Strength can be increased by adding fulcrum, connecting parts and parallel use of double cladding plastic pipes.  When designing the structure, make sure that the main load is applied directly to the pipe fittings and not to the connections.  

The maximum horizontal distance is every 600mm (according to the specific weight of the design of the specific structure) can be built at will, using block type assembly, must be vertical with the ground column support, and every 1200mm, vertical column should be directly to the ground.  In the case of products with casters, the underframe shall be of double rod parallel construction.  The horizontal distance is 600mm, and the safety bearing of a single rod and slide is 30kg.  A whole plastic covering than by the collet string up a few plastic tube strength is stronger, so in the plastic covering tube selection, the stress rod must be the whole rod, the connecting rod can be segmenting.  

When designing a rod product, the usage should be considered in detail. If it does not need to move, try not to design a product with casters.  Line bar products are also known as flexible, according to your site conditions and customer requirements, comprehensive design scheme, flexible disassembly and installation, no welding, practical, automotive, electronics, printing, clothing, dust workshop, installation is more health, no pollution.  

The width of each column of the sliding shelf (center distance) is the width of the turnover box placed +60mm;  The height of each floor is +50mm of the height of the turnover box placed.  The determination of the slope Angle of the slide, the general slope Angle of the slide is 5~8 degrees, when placing precision materials, heavy materials and the bottom of the turnover box is smooth, the slope Angle should be smaller.  

Message

Close